where do I get good pictures of specific motorcycle and lawnmower parts?


Posted August 31st, 2009 by admin 1 Comment »
lawnmower
Traci A asked:


I need detailed pictures of an ‘83 Tri Z 60 cc Yamaha Carburator, Engine and Rear Axle. Vehicle ID # 36R 010887

My Sears Craftsman Eager1 engine(lawnmower) will start for a minute and then stop?


Posted August 31st, 2009 by admin 8 Comments »
lawnmower
Loved By Someone Above asked:


Is it the choke or something else?

How do I fix this lawnmower?


Posted August 31st, 2009 by admin 3 Comments »
lawnmower
Jeeper asked:


When I prime the motor before pulling the cord, the engine will run. After the primed gas runs out, the engine isn’t pulling any gas from the tank, and stops. Also, I get the problem with or without the choke.
When I prime the motor before pulling the cord, the engine will run. After the primed gas runs out, the engine isn’t pulling any gas from the tank, and stops.

How do I calculate the noise level I am exposed to ,0.6m from the exhaust pipe (ride-on lawnmower-source)?


Posted August 31st, 2009 by admin 4 Comments »
lawnmower
Eagle asked:


The manufacturer’s information states that the A-weighted sound power level (SWL) of lawnmower is 93dB

What does A-weghted sound power level (SWL) mean

does anyone have a suggestion on how I would convert a 5 hp lawnmower engine to project water?


Posted August 31st, 2009 by admin 6 Comments »
lawnmower
Robert asked:


I have a 5hp lawnmower engine that I want to turn into a watercannon for cruzin the river with, any suggestions would be greatly appretiated

what is wrong with my lawnmower?


Posted August 24th, 2009 by admin 9 Comments »
lawnmower
EeE asked:


A day ago I was trying to mow my yard and I first made sure that it had sufficient oil and gasoline. I primed it up and when I pulled on the cord it sparked for a second and I mowed about a foot of grass and it died. I tried to start it up again but it just made a really loud pop and it died again. Now every time I try to start it you it won’t spark and start. I’ve just changed the spark plug in it and still the same results.

What could be wrong with it?

why does toro lawnmower engine make popping noise?


Posted August 24th, 2009 by admin 2 Comments »
lawnmower
hopaloong asked:


Recently replaced flywheel key and spark plug on 6.5 hp the engine starts and runs fine except for it sounds like it has a misfire and makes a popping noise I didn’t gap the spark plug cause don’t know what it should be any suggestions?

How come my Craftsman riding lawnmower wont engage?


Posted August 24th, 2009 by admin 1 Comment »
lawnmower
LibbyLibberLove♥ asked:


Well, we cleaned the top of the blades, and everything but it still wont work. what to do?
What i meant was the blades wont engage. Grass sucks :)

I have a craftsman riding lawnmower and when i went to start it?


Posted August 24th, 2009 by admin 4 Comments »
lawnmower
samantha s asked:


it only will run when the clutch is pressed in, you can change gears but when I take my foot off the clutch (which is also the brake) it dies. What could be the problem? Is there an easy fix for it?
I assume the blade is disengaged, but when you touch the handle to check it will shut off.

why does my lawnmower stall out over grass only?


Posted August 24th, 2009 by admin 5 Comments »
lawnmower
Wanda asked:


it starts fine, idles good and then when I go over grass that needs to be mowed it stalls out. In low grass, no problem.
but I have cut higher grass than this before and never had the problem. wouldn’t there be something wrong with it?