Quality Lawnmowers

nwstrtn asked:


I have a B&S 18HP Twin riding lawnmower. I pulled my boat out of the garage with it and something snapped,I pulled the engine cover and the oneside piston goes back and forth but the other doesn’t. So I think a connecting rod is broken. How do I get to that to repair that or is it worthed?

Megan asked:


I have a 4.75hp briggs and stratton lawnmower. After cutting particularly high grass, my engine has been running slower and then eventually stopping. I changed the air filter, but the engine continues run unevenly and dies out after a short time. Any help if solving this would be appreciated.

Lisa R. asked:


I have been trying to remove a rusted pulley from a shaft in a lawnmower engine and broke a bolt puller trying to do it. I need help. Thanks.
Thank you so much for all your answers. Will try them all out!

slyone36 asked:


Have a Murray walk behind lawnmower and need to replace the 2 back wheels (hard plastic), but they measure 7 1/2 inches from top to bottom but they make 7 and 8 inch wheels, I guess maybe 7 inch?

G S asked:


position and seems to be missing at lower revs before cutting out. I have thoroughly cleaned carburettor and made new manifold gasket, but still the same. Any advice most welcome
Trueness of flange is a goodie, checked that before reseating. thanks your reply.

Casey v asked:


I’mm working on this lawnmower for a friend, and just wanted to gather a little information before I start. It has the 9hp Kawasaki balanced engine with the cast iron cylinder OHV and electric start. I dont have a manual. The lawnmower doesnt start and has sat for two years. They have replaced the battery numerous times. Also, the starter was recently replaced along with the switch. The problem is definitly electrical/charging related. Heres what I’m going to do. Tell me if you have any other ideas or if you’ve had problems similar. Thank you.

- Change the Oil and Filter
- Siphon out the Gas from the Tank
- Change the Spark Plug
- Replace the Battery
- Clean all Electrical Connections and Safety Switches
- Check the condition of the Belts
- Clean the Carb
- Sea Foam the Engine
- TEST THE STATOR (I believe this is the problem)

What do you think?

Kyle asked:


my mom poured gas where the oil is supposed to be. Not a lot. But enough probably/. THere is some leaking out towards the front of teh engine .

Huntinglover asked:


my Yard Man riding lawnmower 38″ cut discharges a thin strip of grass clippings out the non discharge side as well as the clippings being discharged out the proper side.it is a nice neat strip of clippings.looks like a miniature windrow of cut alfalfa.lol. i cant figure it out,blades are sharpened every 3-4 weeks,deck is cleaned each week,tires are all to correct pressure.any ideas or solutions? this problem just started this season.

Mogi asked:


Well my lawnmower won’t start I pull it and then at a point it locks and I can’t pull further and so I have to let go. it has enough gas but I was mowing for a bit and then it made a weird squeaky noise and stopped. I checked the oil and saw it was black. can you guys help me im afraid that I burnt out my lawnmowers engine.

troyman2000us asked:


I have a Troy Bilt Model 675 Selp Propel lawmower. I accidentally put gas in oil tank. I have drained the oil tank but it still smells like gas in there. I just don’t want to ruin the lawnmower. Is there anything else I need to do other than refilling the oil tank?